NFPA 99 Risk Assessment
by Bob Armbrister, on Feb 5, 2020 12:00:00 AM
Q: A question came up concerning NFPA 99 (2012) Risk Assessment. Does this only pertain to new construction or does it pertain to existing buildings also? Our company has never had an assessment done in the past but it is my understanding that it became a requirement in 2016. The CMS has established compliance requirements (K Tag) for risk assessment and its completion. Who would be the qualified personnel to perform this procedure and create a formal and documented risk assessment?
A: According to members of the Technical Committee who wrote the new Chapter 4 in NFPA 99-2012, the original intent was the risk assessment only applies to new construction. However, the way chapter 4 is written, it is not clear that the risk assessment is only applicable to new construction. CMS has instructed their state agencies who survey on their behalf to require all hospitals to have completed their NFPA 99 risk assessment for new as well as existing construction. Therefore, hospitals must conduct the risk assessment for new and existing conditions. These assessments are not difficult to do and only take a few minutes. There is no requirement to make a room-by-room assessment, but the intent is to assess the risk of the entire system if it were to fail and there were no back-up systems. It would stand to reason that most hospital systems would be Category 1 or Category 2. Anyone may conduct the assessment but would have to have knowledge of the risk assessment process and knowledge of the facility.